Second Generation Supra Intake Pipe Kit Installation Instructions

1. Remove plastic/rubber factory intake tract, leaving air flow meter in the factory location. You will not re-use any bolts, clamps, or couplings.

2. Slide small end of the silicone transition hose (2.75" ID) over the inlet of the throttle body, until it rests against the raised stops.

3. Slide the other piece of silicone (3” ID) hose over outlet of air flow meter, until the middle of the coupling is at the edge of the outlet.

4. Loosely install hose clamps onto both silicone couplings (place clamps in the same position, for aesthetic reasons).

5. Slide end of intake pipe into throttle body coupling, with vacuum ports facing toward front of car.

6. Slide the other end of intake pipe into the coupling on the air flow meter.

7. Adjust couplings and piping until it looks “nifty” (there should be one eighth to one quarter inch clearance between the intake pipe and passenger side valve cover).

8. Install vacuum hoses.

9. Tighten hose clamps.

10. Enjoy